Thanks for being there …

Last week I didn’t get to do much crafting so I missed one or two challenges that I usually like to participate in. This week it is easier so I’m back in my craft room trying to regain some mojo. I don’t do a lot using pastels so decided to have a go with this challenge at JUG’s.

I pulled out some marble paper that was gifted to me and cut a frame, using Hero Arts Infinity dies, for the card front. I also cut a circle, also Hero Arts, to go behind the dotted die piece. This die is from Your Next Stamp (sadly closing shop). With an older SSS set called Lifting Hearts I stamped the cute image, coloured it with pencils and then covered it with Versamark ink so I could heat emboss it. Once I had one coat done I repeated it only this time I used the Ultra Thick powder and kept adding it until I was happy with the result. I die cut several pieces so I could stack them for a bit of dimension and now the image is shiny and to me, quite pretty. Using a stamp from the same set I added the sentiment at the bottom. I decided against any embellishments but may change my mind later on.

I hope you are having a good day, and thanks for taking a look.

12 thoughts on “Thanks for being there …”

  1. Great shine on your “floating” image. It is adorable and the use of marble patterned paper peeking out from the the edges and fun circle die is a great design and card.

    Liked by 1 person

    1. Many thanks. I used to do this a lot in the past and then forgot about it. Saw a video that reminded me and thought it time to try again. Glad you like the card.

      Liked by 1 person

Leave a comment