lavenderhousecreations

paper piecing

Inkspirational Challenge #308 – Designer’s Choice – Paper Piecing

I just purchased this die from Kokorosa as I had seen it a few times and liked it. It’s a great way to use up some PP actually. Anyway I pulled out some StampinUp DSP that I like and cut the frame and then I also cut some regular CS so I could give it some stability and dimension. The die comes with all the additional pieces so you can cut out smaller curved bits. Once I had built up my outer frame, I took all the fallouts and put them in order so I could add the other PP on top. Then I popped each one back into the section it came from. I ended up with a tiny amount of white showing here and there as it wasn’t easy to make them fit exactly. The initial frame bends out of shape just a little and I think this is the reason it was more challenging. That said it isn’t so bad that I would discard the card. The sentiment is from MFT and I had it from a previous project where I changed my mind because I found it a bit big. For this card is works well. I quite like the end result and it is a card than can be used for a male or a female.

Thanks for stopping by and thanks in advance for any comments you leave. I appreciate each and every one.

12 Comments

12 thoughts on “paper piecing”

Leave a reply to Judy Inukai Cancel reply